topic ISE Policy set - Condition Value missing in Network Access Control

ISE Policy set - Condition Value missing

manvik — Wed, 13 May 2020 04:19:15 GMT

Guys, something strange. Am creating new policy set and setting the condition. I can select "Device Type" > " Equals" >
Next part is to select "All device Types" from Drop-down.

There is no value, it's empty in the drop-down. Any idea why this is happening.

I checked the Network Device Type page too. It contains "All Device Types" list.

Re: ISE Policy set - Condition Value missing

paul — Wed, 13 May 2020 04:40:45 GMT

In your picture it is not empty. It has two values in it. There are a few know bugs with the condition studio. If you create a new object like a device type and then go right to the condition studio it probably will not show up in the list. Go to a different screen and come back and it will be there. I have seen rare occasions where the drop down doesnt do anything but again navigating away from that screen and coming back usually fixes it.

Re: ISE Policy set - Condition Value missing

manvik — Wed, 13 May 2020 04:43:49 GMT

Thank You Paul,

It's a sample image used. I tried navigating to other screens and coming back, still same.

Re: ISE Policy set - Condition Value missing

paul — Wed, 13 May 2020 04:55:41 GMT

Try a different browser, put in a screen shot of what you are seeing when you click the drop down. What version and patch are you on?

Re: ISE Policy set - Condition Value missing

manvik — Wed, 13 May 2020 13:21:14 GMT

Thank You,

It worked today. Did nothing.

Morning when I opened the page it worked.