topic aaa new-model % Unrecognized command in Network Access Control

aaa new-model % Unrecognized command

anishinc4u — Wed, 10 Jun 2020 10:29:28 GMT

am trying to enable aaa new-model in cisco SG300 switch, but getting below mentioned error.

switch(config)#aaa new-model
% Unrecognized command

can anybody let me know, what am missing here.

Thanks..Anish

Mark Elsen — Wed, 10 Jun 2020 10:44:49 GMT

- For 'safety' use latest firmware version if not yet done, and verify the issue again.

anishinc4u — Wed, 10 Jun 2020 11:30:29 GMT

am using the latest firmware which is available now.

Thanks..Anish

Anurag Sharma — Wed, 10 Jun 2020 11:46:23 GMT

Not sure about the CLI of this device, but it seems it has quite a nice UI to configure RADIUS, TACACS, 802.1x.

See the following KBs:

poongarg — Wed, 10 Jun 2020 13:51:30 GMT

In the Cisco Small Business Switches does not exist the aaa new-model command. Here is the CLI guide for your reference:
https://www.cisco.com/c/dam/en/us/td/docs/switches/lan/csbms/sf30x_sg30x/administration_guide/CLI_300.pdf

Greg Gibbs — Wed, 10 Jun 2020 23:18:41 GMT

You should also note that the SG300 is not listed in the ISE Network Component Compatibility list, so it has not been tested/validated against ISE.