topic Re: ISE and e-mail alerts in Network Access Control

ISE and e-mail alerts

paul1202 — Wed, 24 Jun 2020 05:57:01 GMT

Hello,

When configuring e-mail alerts, is it possible to always know which appliance in a distributed deployment is sending the alarm alert?

I understand that all appliances send e-mail alerts, but it is the MnT that sends the alarm e-mails and will use the sender e-mail address specified in the PAN. Is that correct?

Is there a table that lists all the alerts sent from each persona? (ISE 2.6)

Thanks,

Paul

Re: ISE and e-mail alerts

Greg Gibbs — Thu, 25 Jun 2020 03:02:27 GMT

If you're talking about emails sent based upon triggered Alarms, only the MnT node sends these emails. See the ISE Ports Reference for SMTP flows related to the various nodes.

The sender/receiver emails are configured in the Alarm Notification tab of the Administration > System > Settings > Alarm Settings page. You can also override the global receiver settings for a particular Alarm by configuring receivers for the individual Alarm in the Alarm Configuration tab.