topic Re: ISE question regrding ISR1000 series router ( C1111-4PLTEEA ) IOS-XE Everest 16.6.7 in Network Access Control

ISE question regrding ISR1000 series router ( C1111-4PLTEEA ) IOS-XE Everest 16.6.7

ade5 — Mon, 02 Dec 2019 17:02:05 GMT

Good morning ,

I do not see the "ip device tracking" command when configuring this ISR router . Is the "ip device tracking" command old and being replaced in this ios version ?

What is the alternative configuration so that the ISR router will send ip address information to ISE on this router ?

thanks

Re: ISE question regrding ISR1000 series router ( C1111-4PLTEEA ) IOS-XE Everest 16.6.7

howon — Fri, 06 Dec 2019 06:52:48 GMT

We have not gone through compatibility work with ISR 1000 & ISE. What use case are you trying and is this for wireless or wired?

Re: ISE question regrding ISR1000 series router ( C1111-4PLTEEA ) IOS-XE Everest 16.6.7

Alejandro Rodriguez — Tue, 25 Aug 2020 22:15:17 GMT

I have the same problem.

I triying for wired.

Re: ISE question regrding ISR1000 series router ( C1111-4PLTEEA ) IOS-XE Everest 16.6.7

Greg Gibbs — Tue, 25 Aug 2020 22:46:43 GMT

I'm not sure if the feature is available for the ISR1000, but check if the SISF-based Device Tracking feature for Everest code on the Cat3850 is available in the command structure on the ISR.

https://www.cisco.com/c/en/us/td/docs/switches/lan/catalyst3850/software/release/16-6/configuration_guide/sec/b_166_sec_3850_cg/configuring_sisf_based_device_tracking.html

As @howon mentioned, however, the ISR1000 has not been tested/validated against any current version of ISE.

Re: ISE question regrding ISR1000 series router ( C1111-4PLTEEA ) IOS-XE Everest 16.6.7

Alejandro Rodriguez — Wed, 26 Aug 2020 15:39:02 GMT

Thanks four your reply.

SISF-based Device Tracking, is not Support on ISR 1100.