topic ISE - How to export endpoint database with all attributes? in Network Access Control

ISE - How to export endpoint database with all attributes?

mini — Sun, 01 Nov 2020 13:56:49 GMT

I need to compare unit attributes captured from the different probes.
If I go to "Context Visibility" -> "Endpoints" -> "Export" I get a database (CSV) that misses most of the various attributes.
Is there a way to extract all the information?

ISE runs 2.7.

Re: ISE - How to export endpoint database with all attributes?

Mohammed al Baqari — Sun, 01 Nov 2020 14:45:45 GMT

Hi,

Have you tried to go reports > diagnostics > endpoints. See if this
fulfill your requirement.

***** please remember to rate useful

Re: ISE - How to export endpoint database with all attributes?

CarlCarlson1234 — Mon, 02 Nov 2020 20:49:11 GMT

If you have access to use it, try the ISE Endpoint Analysis tool by Cisco. Or an endpoint dump from the admin cli might have the attributes you're looking for, application configure ise, option 16.

Re: ISE - How to export endpoint database with all attributes?

Damien Miller — Mon, 02 Nov 2020 23:33:10 GMT

The Cisco EAT tool is the ideal candidate for this, I tend to have a lot of problems trying to run it myself. If you can get it to work and it doesn't crash, then it probably has the attributes the OP is after.

Not sure if it is publicly accessible though.

https://iseeat.cisco.com/

Re: ISE - How to export endpoint database with all attributes?

martin.fischer — Thu, 05 Nov 2020 12:00:18 GMT

Hi @mini

SSH into your ISE and enter the command 'application configure ise'. There you have the option 'Get all Endpoints'. This creates a CSV with most of the information available.