topic Re: WOL not working with ise in Network Access Control

WOL not working with ise

GlynnNewey0470 — Tue, 10 Nov 2020 20:04:31 GMT

wol not working with ISE authentication

We have had wake on lan working without ISE authentication, since the desktops have been linked to ise we can no longer use wake on lan to turn on the relevant machines

The machines have been added to ISE using mab authentication no issues what so ever, they move onto the correct vlan, the only thing that does work is wol

I have seen using the command on the relevant port, before the authentication part of the port config

is there anything else I need to be aware of (guessing a lot more than just the command below)

authentication control-direction in

Re: WOL not working with ise

Mark Elsen — Wed, 11 Nov 2020 08:16:25 GMT

- Check if this thread is helpful :

https://community.cisco.com/t5/network-access-control/can-wol-work-while-port-configured-to-authenticate-through-ise/m-p/2822816

Re: WOL not working with ise

GlynnNewey0470 — Wed, 11 Nov 2020 08:58:52 GMT

Tried authentication control-direction in still no luck

switchport access vlan xxxx

switchport mode access

authentication control-direction in

authentication host-mode multi-domain

authentication order mab dot1x

notice that mab is the first not dot1x

Guessing its something to do with that

Re: WOL not working with ise

Mark Elsen — Wed, 11 Nov 2020 09:02:26 GMT

- I have moved this to Network Access Control

Re: WOL not working with ise

hslai — Sat, 14 Nov 2020 03:07:29 GMT

IEEE 802.1x Authentication with Wake-on-LAN has a note that PortFast needs enabled on the port.