https://community.cisco.com/t5/network-access-control/radius-session-overlap-between-simultaneous-wireless-dot1x-and/m-p/4293349#M565546 <P>ISE 2.7</P><P>&nbsp;</P><P>If a user connects their device to a Wireless dot1x SSID AND AnyConnect at the same time, ISE does not show separate sessions as Radius reports the same username and mac address for both.</P><P>&nbsp;</P><P>The most recent to connect simply re-uses the existing session from the first: "RADIUS is re-using an existing session"</P><P>&nbsp;</P><P>This is not a big deal to me, but it is confusing our technicians... looking for a Wireless client and not finding it because session is from AnyConnect or vis versa.&nbsp; Many unwanted support cycles.</P><P>&nbsp;</P><P>Is there a way to differentiate here?</P><P>&nbsp;</P> Wed, 17 Feb 2021 23:00:20 GMT Matt Craig 2021-02-17T23:00:20Z https://community.cisco.com/t5/network-access-control/radius-session-overlap-between-simultaneous-wireless-dot1x-and/m-p/4293349#M565546 <P>ISE 2.7</P><P>&nbsp;</P><P>If a user connects their device to a Wireless dot1x SSID AND AnyConnect at the same time, ISE does not show separate sessions as Radius reports the same username and mac address for both.</P><P>&nbsp;</P><P>The most recent to connect simply re-uses the existing session from the first: "RADIUS is re-using an existing session"</P><P>&nbsp;</P><P>This is not a big deal to me, but it is confusing our technicians... looking for a Wireless client and not finding it because session is from AnyConnect or vis versa.&nbsp; Many unwanted support cycles.</P><P>&nbsp;</P><P>Is there a way to differentiate here?</P><P>&nbsp;</P> Wed, 17 Feb 2021 23:00:20 GMT https://community.cisco.com/t5/network-access-control/radius-session-overlap-between-simultaneous-wireless-dot1x-and/m-p/4293349#M565546 Matt Craig 2021-02-17T23:00:20Z