https://community.cisco.com/t5/network-access-control/more-interfaces-enabled-before-posturing/m-p/4417098#M567808 <P>AnyConnect NAM is for 802.1X auth but not for posture. By default, all supported interfaces are controlled by NAM. If needed, you may remove an interface from NAM control by clearing the checkbox in the interface properties page.</P> Sat, 12 Jun 2021 01:35:40 GMT hslai 2021-06-12T01:35:40Z https://community.cisco.com/t5/network-access-control/more-interfaces-enabled-before-posturing/m-p/4415954#M567768 <P>Hello,&nbsp;</P><P>&nbsp;</P><P>I have ISE with posturing with NAM agent Cisco AnyConnect</P><P>&nbsp;</P><P>I would like to ask if it is possible to allow an ethernet card enabled, apart form the virtual of Cisco AnyConnect.</P><P>&nbsp;</P><P>Is there any documentation?</P><P>&nbsp;</P><P>Thanks and regards,&nbsp;</P><P>Konstantinos</P><P>&nbsp;</P><P>&nbsp;</P> Thu, 10 Jun 2021 08:47:29 GMT https://community.cisco.com/t5/network-access-control/more-interfaces-enabled-before-posturing/m-p/4415954#M567768 kostasthedelegate 2021-06-10T08:47:29Z https://community.cisco.com/t5/network-access-control/more-interfaces-enabled-before-posturing/m-p/4417098#M567808 <P>AnyConnect NAM is for 802.1X auth but not for posture. By default, all supported interfaces are controlled by NAM. If needed, you may remove an interface from NAM control by clearing the checkbox in the interface properties page.</P> Sat, 12 Jun 2021 01:35:40 GMT https://community.cisco.com/t5/network-access-control/more-interfaces-enabled-before-posturing/m-p/4417098#M567808 hslai 2021-06-12T01:35:40Z