https://community.cisco.com/t5/network-access-control/c9300-radius-dacl-question/m-p/4426410#M568246 <P>DACLs only apply to inbound traffic to the port. None of the Cisco switching platforms (that I'm aware of) support DACLs that apply to traffic outbound from the switchport.</P> Wed, 30 Jun 2021 22:43:39 GMT Greg Gibbs 2021-06-30T22:43:39Z https://community.cisco.com/t5/network-access-control/c9300-radius-dacl-question/m-p/4425952#M568231 <P>We are implementing dACL with RADIUS on a C9300 switch with IOS 16.9</P><P>&nbsp;</P><P>Our configuration seems to be correct and we have the inbound dACL working on a switchport</P><P>Cisco-AVpair = "ip:inacl ...."</P><P>&nbsp;</P><P>But the outbound acl is not applied or rejected</P><P>Cisco-AVpair = "ip:outacl ...."</P><P>&nbsp;</P><P>Are outbound dACL with Radius not supported by this switch? Or is it an IOS version issue?</P><P>&nbsp;</P><P>&nbsp;</P><P>&nbsp;</P><P>&nbsp;</P> Wed, 30 Jun 2021 09:13:12 GMT https://community.cisco.com/t5/network-access-control/c9300-radius-dacl-question/m-p/4425952#M568231 wipo 2021-06-30T09:13:12Z https://community.cisco.com/t5/network-access-control/c9300-radius-dacl-question/m-p/4426410#M568246 <P>DACLs only apply to inbound traffic to the port. None of the Cisco switching platforms (that I'm aware of) support DACLs that apply to traffic outbound from the switchport.</P> Wed, 30 Jun 2021 22:43:39 GMT https://community.cisco.com/t5/network-access-control/c9300-radius-dacl-question/m-p/4426410#M568246 Greg Gibbs 2021-06-30T22:43:39Z