https://community.cisco.com/t5/network-access-control/ise-for-certain-users/m-p/4433801#M568484 <P>Absolutely.&nbsp; See here for further details:&nbsp;<A href="https://community.cisco.com/t5/security-documents/ise-secure-wired-access-prescriptive-deployment-guide/ta-p/3641515#toc-hId-1178514092" target="_blank">ISE Secure Wired Access Prescriptive Deployment Guide - Cisco Community</A></P> Thu, 15 Jul 2021 13:58:53 GMT Mike.Cifelli 2021-07-15T13:58:53Z https://community.cisco.com/t5/network-access-control/ise-for-certain-users/m-p/4433754#M568482 <P>Good day all,</P><P>&nbsp;</P><P>We are slowly stepping into using ISE for lan access control. In testing this, is there a way to only test it for few user ports on cisco 3800 switches only? This is so as to only test on few selected user ports so less issues are caused for others. &amp; is there an easy way to take this off - simple port config?</P><P>&nbsp;</P><P>Thanks.</P> Thu, 15 Jul 2021 13:13:18 GMT https://community.cisco.com/t5/network-access-control/ise-for-certain-users/m-p/4433754#M568482 suthomas1 2021-07-15T13:13:18Z https://community.cisco.com/t5/network-access-control/ise-for-certain-users/m-p/4433795#M568483 <P>&nbsp;</P> <P>&nbsp;- You can limit dot1x or mab port-configurations to selected ports in a migration traject (e.g.)</P> <P>&nbsp;M.</P> Thu, 15 Jul 2021 13:53:07 GMT https://community.cisco.com/t5/network-access-control/ise-for-certain-users/m-p/4433795#M568483 Mark Elsen 2021-07-15T13:53:07Z https://community.cisco.com/t5/network-access-control/ise-for-certain-users/m-p/4433801#M568484 <P>Absolutely.&nbsp; See here for further details:&nbsp;<A href="https://community.cisco.com/t5/security-documents/ise-secure-wired-access-prescriptive-deployment-guide/ta-p/3641515#toc-hId-1178514092" target="_blank">ISE Secure Wired Access Prescriptive Deployment Guide - Cisco Community</A></P> Thu, 15 Jul 2021 13:58:53 GMT https://community.cisco.com/t5/network-access-control/ise-for-certain-users/m-p/4433801#M568484 Mike.Cifelli 2021-07-15T13:58:53Z