Wired authentication - 802.1x and MAB - Continuous EAP Request-ID

Noble — Wed, 15 Sep 2021 19:31:28 GMT

Hello,

I have ports configured for both 802.1x and MAB.

Clients that do not support 802.1x with authenticate using their MAC address.

I have noticed that even though a client successfully authenticates using their MAC address the switch will continuously send EAP-Identity-Requests to the client. The client will not respond, however the switch will endlessly send requests regardless of the MAC authentication state.

Is this expected behavior for ports running parallel authentication methods? I would expect it to stop/eventually timeout if the client does not respond or has already MAC authenticated?

Thanks,

Re: Wired authentication - 802.1x and MAB - Continuous EAP Request-ID

Mark Elsen — Thu, 16 Sep 2021 05:47:30 GMT

- Show the running-config of the particular port(s)

topic Re: Wired authentication - 802.1x and MAB - Continuous EAP Request-ID in Network Access Control

Wired authentication - 802.1x and MAB - Continuous EAP Request-ID

Re: Wired authentication - 802.1x and MAB - Continuous EAP Request-ID