Radius Server Priority

naoki_Japan — Wed, 20 Oct 2021 10:59:24 GMT

I aim to configure the radius server group, which works as fail-over not round-robin or load-balancing.

And configured as below.

/////////////////////////////////////////////////////////////////////////////////////////////////////////////////////////////////////////////////////////

aaa group server TEST_Group

server name A_radius

server name B_radius

server name C_radius

radius server A_radius

address ipv4 10.10.10.1 ~~~~~~~~~

radius server B_radius

address ipv4 10.10.10.2 ~~~~~~~~~

radius server C_radius

address ipv4 10.10.10.3 ~~~~~~~~~

/////////////////////////////////////////////////////////////////////////////////////////////////////////////////////////////////////////////////////////

I expected that the priority order is

A_radius 1

B_radius 2

C_radius 3.

However, in contrary to my wish, the actual log output by the command "show aaa servers" is

B_radius 1

A_radius 2

C_radius 3

How could I manipulate these priority as I expect ?

Re: Radius Server Priority

balaji.bandi — Wed, 20 Oct 2021 11:14:34 GMT

If this is order -

I expected that the priority order is

A_radius 1

B_radius 2

C_radius 3.

May be due to some reason i am thinking Radius 1 one failed some reason, so the prority is changed here i guess (make sense ?)

Re: Radius Server Priority

naoki_Japan — Thu, 21 Oct 2021 06:25:51 GMT

I found that A_radius server once failed, which caused the change of the priority.

THX

topic Re: Radius Server Priority in Network Access Control

Radius Server Priority

Re: Radius Server Priority

Re: Radius Server Priority