topic Re: Installation of ISE AnyConnect via GPO in Network Access Control

Installation of ISE AnyConnect via GPO

laurathaqi — Mon, 15 Nov 2021 08:18:43 GMT

Dear community,

How do I install the ISE AnyConnect Posture module and its components to hosts via GPO?! Is there a guide on how to do this?

Thank you,

Laura

Re: Installation of ISE AnyConnect via GPO

balaji.bandi — Mon, 15 Nov 2021 10:05:12 GMT

Look at the below thread :

https://community.cisco.com/t5/network-access-control/anyconnect-deploy-with-sccm-help/td-p/3000498

Re: Installation of ISE AnyConnect via GPO

laurathaqi — Mon, 15 Nov 2021 10:16:20 GMT

Hi @balaji.bandi

Thank you for your feedback!

This one seems to be via SCCM, however, I don't have SCCM solution in place, and was wondering is this can be done via Microsoft GPO somehow!?

Looking forward to hearing from you.

Thank you,

Laura

Re: Installation of ISE AnyConnect via GPO

balaji.bandi — Mon, 15 Nov 2021 10:25:19 GMT

Most i worked have SCCM to deploy, this more look MS point of view, how you distribute the software to various clients.

worth looking below steps :

https://social.technet.microsoft.com/Forums/en-US/3891ab38-eecb-4ff2-8796-caa62a055bd0/how-to-deploy-cisco-ise-agents-through-group-policy?forum=winserverGP

Re: Installation of ISE AnyConnect via GPO

laurathaqi — Wed, 17 Nov 2021 09:05:05 GMT

Hi @balaji.bandi ,

Does someone has a guide on how to deploy the AnyConnect Posture module, including all files of it, via SCCM.

I know there is the AnyConnect web client file, The posture file and the Core File, however, what about the configurations of ISE?

How to point the hosts to ISE and get the ISE configuration of Posture, this all via SCCM?

Thank you,

Laura

Re: Installation of ISE AnyConnect via GPO

balaji.bandi — Wed, 17 Nov 2021 09:33:23 GMT

Looks like you mixing many things one thread, which may other members to help you (apart from me) so it is good to have new topic if this is not the same asked,

but anyway Hope this help you :

https://community.cisco.com/t5/security-documents/how-to-integrate-cisco-ise-with-microsoft-sccm-for-patch/ta-p/3725035

Good video help you understand :

http://www.labminutes.com/sec0279_ise_22_posture_assessment_anyconnect_client_2