topic Re: ISE: Select allowed protocols/servers sequence in policy set in Network Access Control

ISE: Select allowed protocols/servers sequence in policy set

cisco_eng_1 — Fri, 04 Feb 2022 13:59:00 GMT

My question: – Is it possible to disable the requirement to select allowed protocols/servers sequence in policy set in version 2.7 and above?

Back in version 2.2 requirement was only condition and allowed protocols were results for authentication.

1. Is it possible to disable it on version 2.7?
2. Is it possible to disable it in any other versions? 3.0 or 3.1 or any plans for this to be available in future releases?
3. Is it possible to request feature improvement if the above is not possible?

Re: ISE: Select allowed protocols/servers sequence in policy set

Filip Po — Fri, 04 Feb 2022 15:13:52 GMT

Hello,

of course, if you do not want to restrict any of the protocols, then edit Default Network Access list to allow all checkboxes. This will turn off this requirement. If there is only one list, the choosing right one will be easy.

Re: ISE: Select allowed protocols/servers sequence in policy set

thomas — Sun, 06 Mar 2022 00:20:12 GMT

I don't understand.

Pictures would help to understand exactly What you are trying to disable Where.