topic Re: ISE 2.7 SFTP Repository SSH issue in Network Access Control

ISE 2.7 SFTP Repository SSH issue

SydneyMarihoho54099 — Thu, 05 May 2022 15:59:41 GMT

I have a new ISE 2.7 on VMware and I'm trying to connect to the remote repository to get the backup configuration. The challenge is after setting up the Repo using GUI I get error message "xx-ise-02/admin# show repository SFTP-REPO
% Error: Repository SFTP-REPO could not be accessed. In case Backup was Restored on different setup, Please reconfigure the repository passwords (expected behaviour).
% Failure occurred during request" when I try and validate.

I have added the cryto host keys and even went to the extend of deleting everything and recreating but to no avail.

Any ideas would be welcome

Thanks,

Syd

Re: ISE 2.7 SFTP Repository SSH issue

Mark Elsen — Thu, 05 May 2022 16:21:30 GMT

- On CLI use : debug transfer 7 , then run the command show repository SFTP-REPO , again : post output here.

Re: ISE 2.7 SFTP Repository SSH issue

SydneyMarihoho54099 — Fri, 06 May 2022 13:19:24 GMT

I have resolved this issue and it was caused by the username and password we had been provided which did not match with what was on the remote repository.

Re: ISE 2.7 SFTP Repository SSH issue

akintundeoloyede11 — Tue, 30 Apr 2024 11:04:20 GMT

Pls i need help i am trying to move patch file to cisco ise repository but couldn't this is my output after running the config above, also attached is a screen shot of the repsitory created from GUI.