topic Re: port-security configuration on port-channel/etherchannel in Network Access Control

port-security configuration on port-channel/etherchannel

suranjan — Fri, 13 May 2022 02:57:59 GMT

Is it possible/feasible to configure port-security on the port-channel/EtherChannel configured interface? If not why or if possible what's the procedure?

Re: port-security configuration on port-channel/etherchannel

Kasun Bandara — Fri, 13 May 2022 04:21:25 GMT

etherchannels cannot configure with port security

Re: port-security configuration on port-channel/etherchannel

balaji.bandi — Fri, 13 May 2022 07:08:36 GMT

what kind of port security are you considering here?

https://www.cisco.com/c/en/us/td/docs/switches/lan/catalyst6500/ios/12-2SXF/native/configuration/guide/swcg/port_sec.html#wp1070356

Re: port-security configuration on port-channel/etherchannel

MHM Cisco World — Fri, 13 May 2022 14:09:21 GMT

https://www.cisco.com/c/en/us/td/docs/switches/lan/catalyst4500/XE3-6-0E/15-22E/configuration/guide/xe-360-config/port_sec.html

The allow of port-seucirty on ether channel is depend on SW some support other not.
this guide show you it support for Cat4000 series.

Re: port-security configuration on port-channel/etherchannel

Mike.Cifelli — Sat, 14 May 2022 16:07:40 GMT

Is it possible/feasible to configure port-security on the port-channel/EtherChannel configured interface? If not why or if possible what's the procedure?

-Not sure the desire here. Port sec is typically for access ports if unable to secure the ports via 802.1x. Are there other mechanisms in place: perhaps the switch/es are in a locked TR/enclosure?