topic Re: cisco sg350 switch for vlan assignment with a third party nac in Network Access Control

cisco sg350 switch for vlan assignment with a third party nac

benv — Wed, 23 Nov 2022 09:22:21 GMT

i am deploying a NAC device in my envionment using a third party nac solution

Please can the sg350 switch do vlan assignment, in such a way that when someone connects to a port he or she is redirected to a compliance port before accepted into the companies wide network. for a fact i know the sg250 only allows this config on the internal switch configuration but i read elsewhere that upgrading to the sg350 has such capabilities if it does can you please share the link to the configuration steps

Also i will like to know what radius features are supported on this feature and if it has all the radius feature to work with my nac device

Lastly, is the below statement correct

Cisco SMB switches mostly don’t pack all the RADIUS features, checking further on the 350x seems it only accepts 802.1x OR MAC auth on the same port so laptops/PCs cannot connect back to back to the same port.

Re: cisco sg350 switch for vlan assignment with a third party nac

benv — Thu, 24 Nov 2022 07:26:01 GMT

Please assist

Re: cisco sg350 switch for vlan assignment with a third party nac

balaji.bandi — Thu, 24 Nov 2022 10:11:02 GMT

check below :

https://www.cisco.com/c/en/us/support/docs/smb/switches/cisco-small-business-300-series-managed-switches/smb5105-configuring-802-1x-on-sg300-series-switches.html

Cisco SMB switches mostly don’t pack all the RADIUS feature

not sure what features ?

Re: cisco sg350 switch for vlan assignment with a third party nac

benv — Thu, 24 Nov 2022 10:46:56 GMT

Thank you for your response

1. Does this switch allow for dynamic vlan assignment using a third party nac and if it does please share configuration link

2. Does it support radius DM/CoA

3. Can we enable this switch currently for 802.1x and mac authentication aas we have noticed that enabling both at thesame time does not work

Lastly once 802.1x is enabled on the switch and a port is configured for it we noticed the switch starts flickering by going up and down, we have upgraded the firmware of the switch but same issues keeps happening

Re: cisco sg350 switch for vlan assignment with a third party nac

benv — Fri, 25 Nov 2022 17:25:25 GMT

????