topic Re: Repository Verification Failed - 3.1 to 3.2 Preparation Upgrade in Network Access Control

Repository Verification Failed - 3.1 to 3.2 Preparation Upgrade

Lyn17 — Fri, 24 Mar 2023 17:18:15 GMT

I'm trying to upgrade ISE from 3.1 to 3.2. However, I'm getting "Repository Verification Failed" during the upgrade preparation phase. Currently, I only have local repository which I was able to validate via UI and CLI. Did anyone run to this issue?

Any help would be greatly appreciated.

Re: Repository Verification Failed - 3.1 to 3.2 Preparation Upgrade

Rodrigo Diaz — Fri, 24 Mar 2023 19:04:12 GMT

hi @Lyn17 , in which kind of repository are you seeing the error ? depending upon the way you are upgrading , what you can do is to either attempt to remove the configuration of the repository you got through CLI and attempt to reconfigure it or perhaps using another storage server that is valid to do the upgrade process. the way you can confirm that your repository is fine through CLI is with the command "show repository (repository_name)"

Let me know if that helped you.

Re: Repository Verification Failed - 3.1 to 3.2 Preparation Upgrade

Nancy Saini — Fri, 24 Mar 2023 19:21:04 GMT

Hi @Lyn17 , it seems like there is some issue with fetching file from your repository. Do "debug copy 7" and "debug transfer 7" and run following tests on CLI

show repository <repository name>
copy <Complete URL of repository with upgrade bundle> disk:

#2 will copy the upgrade file to localdisk of ISE. Share the output of above two commands.

Re: Repository Verification Failed - 3.1 to 3.2 Preparation Upgrade

Lyn17 — Mon, 27 Mar 2023 16:31:45 GMT

Hi @jrodrig,

I can see the repository when I used the command "show repository (repo_name). I'm also able to validate it through the GUI via Maintenance > Repository > check Repo_Name > Validate and gets the "Server Response: Repository Validated Successfully".

Re: Repository Verification Failed - 3.1 to 3.2 Preparation Upgrade

Greg Gibbs — Mon, 27 Mar 2023 21:25:50 GMT

Maybe it's related to this bug?
https://bst.cloudapps.cisco.com/bugsearch/bug/CSCwd31524

If that doesn't apply, you will likely need to open a TAC case to investigate.

Re: Repository Verification Failed - 3.1 to 3.2 Preparation Upgrade

Lyn17 — Tue, 28 Mar 2023 09:41:26 GMT

I was able to validate the repository via CLI and UI. I can see the repository and what's in it when using "show repository <repository_name>. I run the urt bundle using the "application install <urtbundle> <repo_name>" and it was installed successfully. I don't know if it's just a bug. I'm still at the version 3.1, since the staging phase on the GUI is failing with the repository validation and memory. I might have to open a ticket with TAC.

Re: Repository Verification Failed - 3.1 to 3.2 Preparation Upgrade

Lyn17 — Tue, 28 Mar 2023 09:43:59 GMT

I'm still in version 3.1. I was using the GUI to do the upgrade and I can't get pass the preparation phase due to repository validation and memory check failing. I might need to open a ticket with TAC to investigate further.