Cisco NFVIS TACACS timeout configuration

karunanithi — Thu, 13 Apr 2023 18:44:30 GMT

All,

I am looking for documentation or steps to modify the default TACACS timeout configuration, as we are implementing the MFA (Mutli Factor Authentication) for authentication it is getting a timeout. I believe the default timeout is 5 Sec. We would like to increase to 30 Sec. However I cannot find any documentation on this topic. I have referred to the below one.

https://content.cisco.com/chapter.sjs?uri=%2Fsearchable%2Fchapter%2Fcontent%2Fen%2Fus%2Ftd%2Fdocs%2Frouters%2Fnfvis%2Fconfig%2F3-9-1%2Fnfvis-config-guide-3-9-1%2Fnfvis-config-guide-3-6-1_chapter_010001.html.xml&platform=Cisco%20Enterprise%20NFV%20Infrastructure%20Software&release=3.9.1

Kindly help

Thanks

Re: Cisco NFVIS TACACS timeout configuration

Greg Gibbs — Thu, 13 Apr 2023 23:12:07 GMT

This question would be better placed in the NFVIS Solutions Community page. This NAC Community is mainly focused on Cisco ISE.

topic Cisco NFVIS TACACS timeout configuration in Network Access Control

Cisco NFVIS TACACS timeout configuration

Re: Cisco NFVIS TACACS timeout configuration