topic Applying Patch 3 to ISE 3.2 - 2 nodes via CLI in Network Access Control

Applying Patch 3 to ISE 3.2 - 2 nodes via CLI

Abdulaziz Loonat — Fri, 15 Sep 2023 14:21:11 GMT

I plan to apply patch 3 to our 2 nodes ISE 3.2 via CLI

Do I need to apply the patch to each node manually or will the patch be applied to the second node once the first node has been successful.

Re: Applying Patch 3 to ISE 3.2 - 2 nodes via CLI

Mark Elsen — Fri, 15 Sep 2023 17:17:14 GMT

- Using the CLI you always have a 'manual sequence' ; and do each node yourself ; which is recommended .

Re: Applying Patch 3 to ISE 3.2 - 2 nodes via CLI

Arne Bier — Sun, 17 Sep 2023 20:17:12 GMT

If you patch via the GUI, then the Primary Admin Node is done first, followed by a non-stop sequence that you can't pre-determine yourself. As long as the patching was successful, the patching continues to the next node. Manual patching gives you complete control over the sequence.