topic Re: Total Endpoints vs Endpoints? Should be in sync? in Network Access Control

Total Endpoints vs Endpoints? Should be in sync?

rezaalikhani — Fri, 30 Aug 2024 09:11:36 GMT

Hi all;

In my ISE implementation (ISE 3.2 Patch 6), in the main dashboard, the numbers appeared in the "Total Endpoints" section is different with "Endpoints" section. Should these sections show the same report? If yes, how can I resolve this problem?

Thanks

Re: Total Endpoints vs Endpoints? Should be in sync?

PSM — Fri, 30 Aug 2024 11:31:23 GMT

Hi, "Total Endpoints" are the endpoints seen by ISE and in the dashboard "Endpoints" are the total number of endpoints which ISE has been successful to profile.

Re: Total Endpoints vs Endpoints? Should be in sync?

rezaalikhani — Sat, 31 Aug 2024 04:11:07 GMT

How is it possible an endpoint is discovered by ISE and ISE cannot profile it (even with attaching Unknown tag on it)?

Re: Total Endpoints vs Endpoints? Should be in sync?

MHM Cisco World — Sun, 01 Sep 2024 10:59:29 GMT

Adminjstration.system>setting>protocol>radius>suppress and reports> unclick the suppress repeated failed clinets

Then check the number

MHM

Re: Total Endpoints vs Endpoints? Should be in sync?

rezaalikhani — Tue, 03 Sep 2024 05:51:05 GMT

I have already tried the solution you mentioned, but got the same result.

Re: Total Endpoints vs Endpoints? Should be in sync?

ahollifield — Tue, 03 Sep 2024 17:47:30 GMT

Because it did not receive enough information via profiling probes to make a decision. Or ISE has no profile for that particular endpoint.