topic Re: Passive ID DC upgrade procedure in Network Access Control

Passive ID DC upgrade procedure

ivan3 — Fri, 17 Aug 2018 20:46:58 GMT

What is the process for upgrading the Passive ID Agent that is installed on the DC's? I do not see a separate download for the Passive ID Agent in the ISE software downloads, so I'm assuming if the agent is updated, it is included in the ISO of the ISE release (or in a patch)? If that is the case, would we need to perform a manual uninstall of the Passive ID Agent on each DC and then re-deploy it from ISE?

Re: Passive ID DC upgrade procedure

Timothy Abbott — Mon, 20 Aug 2018 18:06:43 GMT

If the agent were to be updated, it would be included in ISE as well as posted to CCO. You could then update it on the controllers in one of two ways. Uninstall it from DC and then install the new agent manually, or you could have ISE do it after you have uploaded it. Hope that helps.

Regards,
-Tim

Re: Passive ID DC upgrade procedure

mumustha — Tue, 11 Mar 2025 05:52:39 GMT

We can download it from the ISE Agent page directly.

The download link for agent is not available in CCO