topic LANLITE in Dot1x monitor mode? in Network Access Control

LANLITE in Dot1x monitor mode?

michael Helmbo — Mon, 11 Mar 2019 05:00:40 GMT

Does LANLITE switches support monitor mode? We can't seem to write the authentication open command under the interfaces.

At a min you need "LAN Base"

nspasov — Thu, 11 Sep 2014 22:30:53 GMT

At a min you need "LAN Base" to run that feature. You can check Cisco's "Feature Navigator" to confirm this and any similar queries in the future. I wasn't sure so that is what I used to find out 🙂

I also found this thread helpful:

https://supportforums.cisco.com/discussion/11078736/lan-lite-image-vs-lan-base-image

Thank you for rating helpful posts!

FYI.. LAN lite is not

Venkatesh Attuluri — Tue, 16 Sep 2014 14:30:37 GMT

FYI.. LAN lite is not recommended with ISE 1.2 (if you are planning for one)

good function!! thanks for

stanly426 — Fri, 22 May 2015 06:58:48 GMT

good function!! thanks for all respondent!