topic I am facing the exact same in Network Access Control

ise posture status notapplicable

ibrahim_hassan — Mon, 11 Mar 2019 04:59:04 GMT

Hello ,

after upgrading ISE 1.2 to 1.2.1 , I can't see posture status (pending) although it is working properly. I tried to install patch 1 but the same result.

before upgrading , posture status was Pending when posture status still not reach to ISE.

Any help please , I think it

ibrahim_hassan — Wed, 10 Sep 2014 07:57:10 GMT

Any help please , I think it may be a bug?

I have same problem too. When

lhviet001 — Thu, 11 Sep 2014 09:55:26 GMT

I have same problem too.

When workstation install NacAgent 4.9.4.3 successfully, then the posture will be stucked.

I didn't see about NAC Agent on report: "Posture Detailed Assessment" and "Client Provisioning"

Any help or advice please ? Should I configure the redirect ACL, dACL, switch ACL, or something like that ?

NAC Agent 4.9.4.3 takes a

mohanak — Tue, 16 Sep 2014 13:42:40 GMT

NAC Agent 4.9.4.3 takes a very long time to complete posture

CSCuq52821

Description

Symptom:
NAC Agent 4.9.4.3 takes about an hour to complete posture

Conditions:
using NAC Agent 4.9.4.3

Workaround:
use NAC Agent 4.9.0.51

The posture is working fine ,

ibrahim_hassan — Tue, 16 Sep 2014 16:45:39 GMT

The posture is working fine , but i can't see the "Pending" status in posture status (attached).

it was working before (1.2 patch 5 ) upgrading to 1.2.1 patch1.

This could be bug

Saurav Lodh — Fri, 19 Sep 2014 01:55:24 GMT

This could be bug

I am facing the exact same

hanna.jabbour — Mon, 22 Sep 2014 16:32:11 GMT

I am facing the exact same issue with the latest 1.2.1 patch 2,

Does anybody have any confirmed Bug covering this issue ?

Thanks , Resolved in 1.3 :)

ibrahim_hassan — Wed, 10 Dec 2014 13:18:03 GMT

Thanks , Resolved in 1.3 🙂