topic Hi,A simple answer would be in Network Access Control

Interoperability between ACS versions

tomyip — Mon, 11 Mar 2019 05:32:05 GMT

I have 6 inter-connected ACS appliances used for RADIUS authentication of wireless users. Currently they are running v5.4 and need to upgrade to v5.5. It would be difficult to upgrade them at the same time since they are in different regions in the world. Are there known interoperability issues between v5.4 and v5.5?

Hi,A simple answer would be

Kanwaljeet Singh — Wed, 11 Mar 2015 03:20:23 GMT

Hi,

A simple answer would be no i.e ACS does not support interoperability between ACS 5.4 and ACS 5.5 deployments. For upgrade procedure please look at the link below:

http://www.cisco.com/c/en/us/td/docs/net_mgmt/cisco_secure_access_control_system/5-5/installation/guide/csacs_book/csacs_upg.html#pgfId-1199565

Visit section:

Upgrading an ACS Deployment from 5.4 to 5.5

Normally you should break the cluster and upgrade the secondary servers and then primary.

Regards,

Kanwal

Note: Please mark answers if they are helpful.

Thanks for the feedback. That

tomyip — Wed, 11 Mar 2015 05:01:55 GMT

Thanks for the feedback. That was helpful. I see that v5.6 is out. Any issues with 5.6? Looks like I can follow the same upgrade steps from 5.4 to 5.6.

Yes you can follow the same

mohanak — Wed, 11 Mar 2015 08:19:12 GMT

Yes you can follow the same steps : http://www.cisco.com/c/en/us/td/docs/net_mgmt/cisco_secure_access_control_system/5-6/installation/guide/csacs_book/csacs_upg.html#pgfId-1199421

For the issues in 5.6 you can refer the document : http://www.cisco.com/c/en/us/td/docs/net_mgmt/cisco_secure_access_control_system/5-6/release/notes/acs_56_rn.html#pgfId-256487