topic Hi Abhishek,There is no in Network Access Control

CIsco ISE 1.2 to 1.3 upgrade

abhishek.marat1 — Mon, 11 Mar 2019 05:29:02 GMT

I am planning for an ISE upgrade from version 1.2 to 1.3. I have two nodes (primary admin, secondary monitoring (ISE 3355) in one box and secondary admin, primary monitoring in the other (3315).) and 8 PSNs (all 3315).

My question is after upgrading when we are testing for failover of the HA pairs in both the nodes…are we going to face any technical complications because of the different model numbers. All nodes (2 +8= 10) are in different locations.

I don't believe there are any

nspasov — Tue, 24 Feb 2015 03:25:04 GMT

I don't believe there are any requirements to have identical hardware when it comes to a distributed deployment.

http://www.cisco.com/c/en/us/td/docs/security/ise/1-3/installation_guide/b_ise_InstallationGuide13/b_ise_InstallationGuide12_chapter_00.html#ID-1413-00000042

With that being said, it is probably a good idea to keep the Admin and Monitoring nodes on the same type of hardware specs.

Thank you for rating helpful posts!

Hi Abhishek,There is no

Kanwaljeet Singh — Tue, 24 Feb 2015 03:26:31 GMT

Hi Abhishek,

There is no restriction on the model number but the versions running should be same on primary and secondary in the distributed deployment. Please look at the guidelines below:

http://www.cisco.com/c/en/us/td/docs/security/ise/1-2/user_guide/ise_user_guide/ise_dis_deploy.html#53463

Regards,

Kanwal

Note: Please mark answers if they are helpful.

You must first upgrade the

mohanak — Tue, 24 Feb 2015 08:57:37 GMT

You must first upgrade the secondary Administration node to Release 1.3. For example, if you have a deployment set up as shown in the following figure, with one primary Administration node (node A), one secondary Administration node (node B), one Inline Posture node (IPN) (node C), and four Policy Service nodes (PSNs) (node D, node E, node F, and node G), one primary Monitoring node ( node H), and one secondary Monitoring node (node I), you can proceed with the following upgrade procedure.

http://www.cisco.com/c/en/us/td/docs/security/ise/1-3/upgrade_guide/b_ise_upgrade_guide_13/b_ise_upgrade_guide_chapter_01.html#ID20

Before You Begin : http://www.cisco.com/c/en/us/td/docs/security/ise/1-3/upgrade_guide/b_ise_upgrade_guide_13/b_ise_upgrade_guide_13_chapter_011.html

Thank you!

abhishek.marat1 — Tue, 24 Feb 2015 16:26:19 GMT

Thank you!

abhishek.marat1 — Tue, 24 Feb 2015 16:26:43 GMT

Thank you!

abhishek.marat1 — Tue, 24 Feb 2015 16:27:08 GMT

Thank you!

No problem! If your issue is

nspasov — Wed, 25 Feb 2015 19:32:49 GMT

No problem! If your issue is resolved you should mark the thread as "answered" 🙂