https://community.cisco.com/t5/network-access-control/macsec-switch-to-host-not-working/m-p/2485429#M87138 <P>Do share the configuration policy and log detials</P> Mon, 31 Mar 2014 11:03:30 GMT kaaftab 2014-03-31T11:03:30Z https://community.cisco.com/t5/network-access-control/macsec-switch-to-host-not-working/m-p/2485428#M87137 <P>Hello,</P><P>I am trying to implement macsec only for switch to host segment. I am following below document but still the user is not able to connect.</P><P><A href="http://www.cisco.com/c/en/us/support/docs/lan-switching/8021x/117277-config-anyconnect-00.html" target="_blank">http://www.cisco.com/c/en/us/support/docs/lan-switching/8021x/117277-config-anyconnect-00.html</A></P><P>The only difference in the topology is below, i have two switches.</P><P>Host&lt;-------macsec-------&gt;Switch----&gt;Switch----&gt;ISE</P><P>The host is repeatedly getting username/password prompts.</P><P>Regards,</P><P>Akhtar</P><P>&nbsp;</P><P>&nbsp;</P> Mon, 11 Mar 2019 04:33:39 GMT https://community.cisco.com/t5/network-access-control/macsec-switch-to-host-not-working/m-p/2485428#M87137 Akhtar Samo 2019-03-11T04:33:39Z https://community.cisco.com/t5/network-access-control/macsec-switch-to-host-not-working/m-p/2485429#M87138 <P>Do share the configuration policy and log detials</P> Mon, 31 Mar 2014 11:03:30 GMT https://community.cisco.com/t5/network-access-control/macsec-switch-to-host-not-working/m-p/2485429#M87138 kaaftab 2014-03-31T11:03:30Z