topic Cisco ISE Web interface problem in Network Access Control

Cisco ISE Web interface problem

teymur azimov — Mon, 11 Mar 2019 04:26:48 GMT

Hi Dears,

I did initial configuration to Cisco ISE 3315. I wrote username and password in iintial setup. All of them are ok in CLI. I can access that username and password in CLI mode. Then I want to access web interface. The ISE page is open and i type the username and password(which i typed in initial setup).But i can not acces ISE. I try to use the default username and password which is admin/cisco and it is also fail.

I try to configure the new username and password in CLI and then try access the new one but this is also fail.

I did restart the device but this is not help.

I do not know what is a problem

Is it a sofware version bug?? or I need to do additional configuration for web-based interface??

I erase the password policy which is default have in ISE. but the problem is not solved.

please help me.

Cisco ISE Web interface problem

Saurav Lodh — Mon, 24 Feb 2014 15:03:09 GMT

Please follow similiar discussions from here

https://supportforums.cisco.com/thread/2162667

Cisco ISE Web interface problem

Charlie Moreton — Mon, 24 Feb 2014 15:05:03 GMT

Teymur,

If you can log in to the CLI, use this command to set the password for the CLI:

application reset-passwd ise admin

You will then be prompted to enter the new password and then to confirm it. The admin accounts for the CLI and for the WebGUI are different accounts and should have been synchronized during the initial setup, but may have been changed.

If your CLI account has the proper priveliges, the command above will work.

Please Rate Helpful posts and mark this question as answered if, in fact, this does answer your question. Otherwise, feel free to post follow-up questions.

Charles Moreton