topic Re: Cisco ISE as Radius server in Network Access Control

Cisco ISE as Radius server

jabranzahid — Mon, 11 Mar 2019 04:25:57 GMT

Hello,

I am trying to configure Cisco ISE as radius server for authentication of wireless clients (for network access).

I have configure the WLC to forward the authentication requests to ISE server and configure the account on ISE server with the relevant

group but I can't seem to authenticate.

I need to do this using Layer 3 Web authentication feature on WLC, i.e. client connects using open authentication and

open a web page which leads to a web authentication page on WLC which then forwards the user credentials to ISE

for authentication.

Is there a configuration guide I can find for this scenario ?

Thanks in advance

Jabran Zahid

kaaftab — Fri, 21 Feb 2014 09:28:15 GMT

yes check cisco How to guides for ISE they are very userfull

if you find the reply helpful do rate it

jabranzahid — Fri, 21 Feb 2014 10:11:30 GMT

Thanks for reply but I have not been able to find a guide for ISE server radius configuration. Can anyone please point me to a relevant link.

kaaftab — Fri, 21 Feb 2014 11:12:56 GMT

you can download the guide from the link given

Note:

If you find the reply helpful do rate it

jabranzahid — Fri, 21 Feb 2014 11:20:24 GMT

There is a whole bunch of guides in that link. If I could get a little bit specific reply to my question, that would be helpful.

thanks

Wing Man — Mon, 24 Feb 2014 17:08:19 GMT

Could you not use the guest portal on the ISE?

To set it up your way is just a longwinded. But I have the same kind of setup, for one of my older controllers.

What do your Authentication logs on your ISE say? Is it even reaching the ISE?