topic Distributed system with different hardware in Network Access Control

Distributed system with different hardware

Tuyen Nguyen — Mon, 11 Mar 2019 04:19:14 GMT

Greetings

I would like to know if I can create a distributed system with 2 different ACS appliances/instances (1121 and 3415) with same version. If not possible I would like to retrieve the configuration(Network devices and AAA client, command shell etc) replication to build another distributed system with identical instance (hardware and version).

Distributed system with different hardware

edwjames — Fri, 24 Jan 2014 23:18:06 GMT

Hi,

You can create this, no issues.

**Share your knowledge. It’s a way to achieve immortality.
--Dalai Lama**

Please Rate if helpful.
Regards
Ed

Distributed system with different hardware

Tuyen Nguyen — Sat, 25 Jan 2014 16:03:57 GMT

Thanks for the feedback, but I was also wondering if I can retrieve my configuration (Network devices and AAA client, command shell etc) from a primary instance to build another primary instance with a different IP?

I know there is a limitation

Changing the IP may result in undesired side effects on any installed application(s).

Are you sure you want to proceed? Y/N [N]:

Thanks.

Distributed system with different hardware

Javier Henderson — Sun, 26 Jan 2014 19:47:58 GMT

Tuyen,

Yes, you can. Just create a backup on the first server, and restore that backup on the second server.

If doing this from the CLI use the "acs backup" command, so you're just backing up the ACS data. Then, create the second ACS server at the desired IP address, and restore with "acs restore".

Javier Henderson

Cisco Systems

Distributed system with different hardware

Tuyen Nguyen — Tue, 28 Jan 2014 16:40:35 GMT

Thanks worked like a charm

Distributed system with different hardware

Javier Henderson — Tue, 28 Jan 2014 16:46:51 GMT

Sounds good. If you accept the question as answerd, please consider rating the thread.