topic CAM CAS "connected" but cannot open CAS webpage on https ???? in Network Access Control

CAM CAS "connected" but cannot open CAS webpage on https ????

game123 — Mon, 11 Mar 2019 04:16:25 GMT

I am confused.

Yes. I have CAM CAS connected ! and certs looks fine. I have rebooted CAS and CAM both , and can ping eachother, and do ssh to both of them as well, even did service perfigo stop and then start, yet CAM gies me GUI on https but CAS is not giving me https ????

Experts, please advice me some troubleshooting steps. Tired .....

"there is no firewall blocking any ports whatsoever"

awaiting inputs from the globe....

CAM CAS "connected" but cannot open CAS webpage on https ????

Tarik Admani — Tue, 14 Jan 2014 01:13:35 GMT

Hi,

What version of CAS are you running, also what browser are you using? Also are you on the same subnet as the CAS' ip address and is the CAS in virtual gateway?

Thanks,

Tarik Admani
*Please rate helpful posts*

CAM CAS "connected" but cannot open CAS webpage on https ????

game123 — Wed, 15 Jan 2014 10:42:56 GMT

This is resolved. it was not NAC issue, rather in WLC some setting was wrong.

thanks anways.

regards,