ISE - Inline Posture Node Deployment Issue - User can not access network after pass authentication checking

Tai Eric — Mon, 11 Mar 2019 04:51:35 GMT

Hi Experts,

I have recently deployed a ISE iPEP in front of a Aruba WLC in bridge mode. After user pass authentication on Aruba WLC, I can see from Monitoring node that the employee role have been granted to the userand a "permit any any acl" has been pushed to IPN. However, user still can not have any network access. When I issue command :" show pep table accesslist normal" and " show pep table session" on IPN but it show nothing. Did anyone have experience the same issue? or any solution or recommended troubleshooting steps?

Regards,

Eric

http://community

Saurav Lodh — Thu, 18 Sep 2014 15:45:01 GMT

http://community.arubanetworks.com/t5/Controller-Based-WLANs/Does-Aruba-Controller-support-switching-vlan-using-COA/ta-p/194579

topic ISE - Inline Posture Node Deployment Issue - User can not access network after pass authentication checking in Network Access Control

ISE - Inline Posture Node Deployment Issue - User can not access network after pass authentication checking

http://community