topic Re: IDS 4215 access in Network Security

IDS 4215 access

d-popescu — Sun, 10 Mar 2019 10:03:22 GMT

Hello,

Sorry for the question but I am having and IDS 4215 and I cannot log into it. I am using Cisco Rollover cable and CRT or Hyper terminal and I am wondering what it could be. The same cable I am using for PIX , SW, Router and works fine.

Thanks a lot for your help.

Regards,

Mike

Re: IDS 4215 access

a.kiprawih — Mon, 12 Jun 2006 14:30:46 GMT

Hi Mike,

IDS console is similar to other cisco boxes.

baud rate: 9600

data bits: 8

parity: none

stop bits: 1

port: com1, com2 or if you used USB serial, depends (between Com3 to Com5).

Anyway, just check the pin inside the console port, in case it a bit loose. Other than that, could be hardware.

Rgds,

Re: IDS 4215 access

a.kiprawih — Mon, 12 Jun 2006 14:40:22 GMT

Alternatively, try to access via its mgt port. Use either cross-over cable and connect it direct to your pc/laptop, or use hub.

IP Address (default address of sensor): 10.1.9.201

Network Mask (default): 255.255.255.0

Default Route: 10.1.9.1

Web Server Port (default is 443)

http://www.cisco.com/en/US/partner/products/hw/vpndevc/ps4077/products_quick_start09186a00801b10ec.html#wp33292

Rgds,

Re: IDS 4215 access

d-popescu — Mon, 12 Jun 2006 22:05:10 GMT

Hello,

Thank you for your help. After power off and on couple times we manage to get access to IDS.However IDS it is stop booting after is trying to read the image from Hdd. It's apear that we are having bad hardware,

Thanks,

Mike