topic Hi Marvin, in Network Security

ASA 5525-X with Firepower services not showing any interfaces in Firesight Management Center

SHABEEB KUNHIPOCKER — Tue, 12 Mar 2019 13:21:36 GMT

Hi All,

I have an ASA5525-X (version 9.7.1) with firepower module (version 6.2). I added the ASA to the firesight management center, but I cannot see the interfaces of ASA listed in the Firesight Management Center.Please let me know whether anyone had this issue before.

Thanks and Regards

Shabeeb

Have you assigned the Control

Marvin Rhoads — Tue, 11 Apr 2017 16:29:50 GMT

Have you assigned the Control license to the ASA FirePOWER module?

Hi Marvin,

SHABEEB KUNHIPOCKER — Tue, 11 Apr 2017 21:24:52 GMT

Hi Marvin,

I have assigned control, protection, URL and malware licenses.

Is the ASA in routed mode and

Marvin Rhoads — Wed, 12 Apr 2017 02:04:17 GMT

Is the ASA in routed mode and the FirePOWER module inline?

Hi Marvin,

SHABEEB KUNHIPOCKER — Wed, 12 Apr 2017 06:17:00 GMT

Hi Marvin,

The ASA is in routed mode. Currently I am not sending any traffic to Firepower module.

I tried to downgraded the

SHABEEB KUNHIPOCKER — Wed, 12 Apr 2017 08:09:11 GMT

I downgraded the sensor software to 6.1.0 , but still the issue remains.

At ths point, I'd recommend

Marvin Rhoads — Wed, 12 Apr 2017 09:24:59 GMT

At ths point, I'd recommend opening a TAC case.

Hi,

Thiago Cella — Tue, 30 May 2017 00:33:33 GMT

Hi,

Here the same problem with ASA5508, after update the software version to asa981-lfbff-k8.SPA , the problem was fixed.

Re: Hi,

philippe.apetoh1 — Sat, 30 Jun 2018 12:18:16 GMT

Hi All,

I've FMC version 6.2.3, ASA version 9.8(1) and Firepower boot image version 6.2.2.

But Same isssue.

Re: Hi,

Marvin Rhoads — Sat, 30 Jun 2018 13:32:30 GMT

You won't see ASA interfaces in FMC when you're managing an ASA Firepower service module. The ASA interfaces are managed from the ASA itself (via cli or ASDM).

Only with the FTD image would you also manage the ASA interfaces.

Re: Hi,

Florin Barhala — Sun, 01 Jul 2018 05:56:37 GMT

Hi Marvin,

I am probably not getting your last post: on my FMC 6.2.3 on Device Management when I click on any unit (5525 with Firepower sensor) I am sent into a two tabs menu: Device | Interfaces.
Thoughts?

Re: Hi,

Marvin Rhoads — Sun, 01 Jul 2018 06:33:48 GMT

Assignment of interfaces to zones or inline sets for purposes of the Firepower Access Control Policy is via FMC.

Interface management like addressing, etherchannels, redundant interfaces, applying ASA ACL etc. is done from the ASA.

Re: Hi,

Florin Barhala — Mon, 02 Jul 2018 04:20:01 GMT

That should be "crystal clear"