DCEF process is running at 75%

mayambanzumba — Mon, 11 Mar 2019 09:54:39 GMT

Can you advise if there is some way to determine why this particular CEF process on slot 2 is running at 75% while the rest appears to be around 30%?

Cairo#sho ip cef resource

Hardware resource allocation status summary

Green (Normal), Yellow (Caution) Red (Alarm)

Slot HW Resource Name Util Alert

2 E2_Rx_PLU 32 G

2 E2_Rx_TLU 75 Y

4 E3 Rx PLU 25 G

4 E3_Rx_TLU 28 G

5 E3 Rx PLU 25 G

5 E3_Rx_TLU 27 G

6 E3 Rx PLU 25 G

6 E3_Rx_TLU 28 G

9 E3 Rx PLU 25 G

9 E3_Rx_TLU 28 G

11 E3 Rx PLU 25 G

11 E3_Rx_TLU 28 G

I would like to increase the CEF alarm parameters to stop the logs on the router being filled with the CEF resource messages, but I am concerned that this process is running higher than the others.

The device is a GSR with IOS Version 12.0(26)S5a

cisco 12012/PRP (MPC7457) processor (revision 0x00) with 1048576K bytes of memory.

MPC7457 CPU at 1263Mhz, Rev 1.2, 512KB L2, 2048KB L3 Cache

Last reset from sw reset

2 Route Processor Cards

2 Clock Scheduler Cards

3 Switch Fabric Cards

4 OC48 POS controllers (4 POS).

3 Single Port Gigabit Ethernet/IEEE 802.3z controllers (3 GigabitEthernet).

1 Three Port Gigabit Ethernet/IEEE 802.3z controller (3 GigabitEthernet).

1 Four Port Gigabit Ethernet/IEEE 802.3z controller (4 GigabitEthernet).

2 Ethernet/IEEE 802.3 interface(s)

10 GigabitEthernet/IEEE 802.3 interface(s)

4 Packet over SONET network interface(s)

2043K bytes of non-volatile configuration memory.

250880K bytes of ATA PCMCIA card at slot 0 (Sector size 512 bytes).

65536K bytes of Flash internal SIMM (Sector size 256K).

Configuration register is 0x2102

Thanks

Re: DCEF process is running at 75%

David White — Mon, 02 Apr 2007 15:57:09 GMT

Hi mayambanzumba,

I think you would have better luck posting this question to a different forum.

Sincerely,

David.

topic Re: DCEF process is running at 75% in Network Security

DCEF process is running at 75%

Re: DCEF process is running at 75%