https://community.cisco.com/t5/network-security/teaming-for-fmc-1000-management-interface/m-p/3764253#M1012021 Hi,<BR />You cannot team the management interface in FMC. But in 2000/4000 appliance you can choose 10G interface for management.<BR /><BR />Hope This Helps<BR />Abheesh<BR /> Sat, 15 Dec 2018 07:46:45 GMT Abheesh Kumar 2018-12-15T07:46:45Z https://community.cisco.com/t5/network-security/teaming-for-fmc-1000-management-interface/m-p/3764241#M1012020 <P>Hello,</P> <P>&nbsp;</P> <P>I am working on deployment of FMC 1000 appliances in HA for management of FTD appliances.</P> <P>&nbsp;</P> <P>The FMC 1000 has 2 mgmt interfaces. I was trying to figure out if the two interfaces can be configured in a active standby teaming and connect the appliance to two uplink switches.</P> <P>&nbsp;</P> <P>Not able to find any document that pointed if this can be achieved.</P> <P>&nbsp;</P> <P>Appreciate any help.</P> <P>&nbsp;</P> <P>Regards,</P> <P>Aniket</P> Fri, 21 Feb 2020 16:34:38 GMT https://community.cisco.com/t5/network-security/teaming-for-fmc-1000-management-interface/m-p/3764241#M1012020 aniketalashe 2020-02-21T16:34:38Z https://community.cisco.com/t5/network-security/teaming-for-fmc-1000-management-interface/m-p/3764253#M1012021 Hi,<BR />You cannot team the management interface in FMC. But in 2000/4000 appliance you can choose 10G interface for management.<BR /><BR />Hope This Helps<BR />Abheesh<BR /> Sat, 15 Dec 2018 07:46:45 GMT https://community.cisco.com/t5/network-security/teaming-for-fmc-1000-management-interface/m-p/3764253#M1012021 Abheesh Kumar 2018-12-15T07:46:45Z