https://community.cisco.com/t5/network-security/saving-firepower-configuration-changes-when-in-cli/m-p/3759915#M1012280 No need to do a write mem as it's committed within the Firepower shell upon<BR />command execution.<BR /><BR />You can use the show commands to verify your intended change has taken<BR />affect.<BR /> Fri, 07 Dec 2018 23:44:31 GMT phil.hydea 2018-12-07T23:44:31Z https://community.cisco.com/t5/network-security/saving-firepower-configuration-changes-when-in-cli/m-p/3759857#M1012278 <P><STRONG>Saving your changes:</STRONG></P><P>For an ASA with firepower services, if you make a change to firepower <STRONG>CLI</STRONG> configuration such as change IP address in it or something like that, does the change get saved automatically even if you power cycle, or do you need to type some command to save the change permanently?&nbsp; Or do you need to exit to the ASA and write mem in ASA mode to save the firepower module changes?</P><P>&nbsp;</P><P>&nbsp;</P><P>&nbsp;</P> Tue, 12 Mar 2019 14:09:34 GMT https://community.cisco.com/t5/network-security/saving-firepower-configuration-changes-when-in-cli/m-p/3759857#M1012278 Waterbird 2019-03-12T14:09:34Z https://community.cisco.com/t5/network-security/saving-firepower-configuration-changes-when-in-cli/m-p/3759915#M1012280 No need to do a write mem as it's committed within the Firepower shell upon<BR />command execution.<BR /><BR />You can use the show commands to verify your intended change has taken<BR />affect.<BR /> Fri, 07 Dec 2018 23:44:31 GMT https://community.cisco.com/t5/network-security/saving-firepower-configuration-changes-when-in-cli/m-p/3759915#M1012280 phil.hydea 2018-12-07T23:44:31Z