topic Re: PIX Failover in Network Security https://community.cisco.com/t5/network-security/pix-failover/m-p/736765#M1012495 <HTML><HEAD></HEAD><BODY><P>For you to access your switch from inside? I don't see a problem with that.</P></BODY></HTML> Tue, 27 Mar 2007 13:11:53 GMT Danilo Dy 2007-03-27T13:11:53Z PIX Failover https://community.cisco.com/t5/network-security/pix-failover/m-p/736764#M1012494 <P>Hi,</P><P></P><P>Should I use the PIX failover IP address of the outside interface as the default gateway for my external switch?</P><P></P><P>Gavin</P> Mon, 11 Mar 2019 09:52:13 GMT https://community.cisco.com/t5/network-security/pix-failover/m-p/736764#M1012494 gavin.mckee 2019-03-11T09:52:13Z Re: PIX Failover https://community.cisco.com/t5/network-security/pix-failover/m-p/736765#M1012495 <HTML><HEAD></HEAD><BODY><P>For you to access your switch from inside? I don't see a problem with that.</P></BODY></HTML> Tue, 27 Mar 2007 13:11:53 GMT https://community.cisco.com/t5/network-security/pix-failover/m-p/736765#M1012495 Danilo Dy 2007-03-27T13:11:53Z Re: PIX Failover https://community.cisco.com/t5/network-security/pix-failover/m-p/736766#M1012496 <HTML><HEAD></HEAD><BODY><P>Im not sure about the requirements of doing so. Also, if you configure the default-gateway to the failover IP of the Outside interface of PIX, this wont be a good idea because if PIX recieves the traffic on the Failover IP, PIX will not route that traffic. This IP is only used for failover communications between the Outside interfaces of PIX.</P><P></P><P>Regards,</P><P>Vibhor.</P></BODY></HTML> Wed, 28 Mar 2007 02:01:41 GMT https://community.cisco.com/t5/network-security/pix-failover/m-p/736766#M1012496 vitripat 2007-03-28T02:01:41Z