https://community.cisco.com/t5/network-security/asa-fail-over-with-sourcefire-ips/m-p/3011675#M1016551 <P>I have a 5525-X fail over, active standby with source fire IPS. From Firesight when I reboot the sensor, firewall switchs to standby state where sensor is rebooted. How can I stop this from happening?</P> Tue, 12 Mar 2019 13:19:07 GMT QUARK TARO 2019-03-12T13:19:07Z https://community.cisco.com/t5/network-security/asa-fail-over-with-sourcefire-ips/m-p/3011675#M1016551 <P>I have a 5525-X fail over, active standby with source fire IPS. From Firesight when I reboot the sensor, firewall switchs to standby state where sensor is rebooted. How can I stop this from happening?</P> Tue, 12 Mar 2019 13:19:07 GMT https://community.cisco.com/t5/network-security/asa-fail-over-with-sourcefire-ips/m-p/3011675#M1016551 QUARK TARO 2019-03-12T13:19:07Z https://community.cisco.com/t5/network-security/asa-fail-over-with-sourcefire-ips/m-p/3011676#M1016552 <P>On the ASA use:</P> <PRE class="prettyprint">no monitor-interface service-module</PRE> Sun, 05 Mar 2017 19:32:12 GMT https://community.cisco.com/t5/network-security/asa-fail-over-with-sourcefire-ips/m-p/3011676#M1016552 Philip D'Ath 2017-03-05T19:32:12Z