topic You should be able to log in Network Security

Unable to login to WebUI

pablo.arcelcr — Tue, 12 Mar 2019 13:18:01 GMT

Im trying to login to my Defense Center thru the WebUI, I'm able to do so but after a few seconds it logs me off

What could be cause this issue?

If another user (or program)

Marvin Rhoads — Wed, 22 Feb 2017 00:25:03 GMT

If another user (or program) is logging on automatically with the same userid, they will force you off.

I'm the only user working on

pablo.arcelcr — Wed, 22 Feb 2017 02:16:51 GMT

I'm the only user working on that equipment.

Could it be if I use the CLI and the WEB UI at the same time?

You should be able to log

Marvin Rhoads — Wed, 22 Feb 2017 05:47:23 GMT

You should be able to log into Web UI and cli at the same time. I've done that many times without issue.

Has it ever worked? Also, what version of FMC do you have?

Has anyone possibly set a restriction on the source IPs allowed to use the Web UI?

Yes it was working.

pablo.arcelcr — Wed, 22 Feb 2017 16:21:07 GMT

Yes it was working.

I was working in the CPAN since I'm trying to setup the configuration for Splunk.

FMC version that I have is 750.

750 is the appliance model.

Marvin Rhoads — Wed, 22 Feb 2017 16:30:28 GMT

750 is the appliance model.

I meant what software version is it running?

Version is Sourcefire Linux

pablo.arcelcr — Wed, 22 Feb 2017 16:33:08 GMT

Version is Sourcefire Linux OS v5.4.0 (build 126)

That is a pretty old build

Marvin Rhoads — Wed, 22 Feb 2017 16:54:38 GMT

That is a pretty old build although I don't see any BugIDs that would obviously cause this behavior.

If you have support, perhaps you can open a TAC case and have them take a look at it.

Re: Unable to login to WebUI

bilaal.amin — Wed, 11 Sep 2019 09:38:23 GMT

Hi all,

I have an ASA 5516-X with Firepower module version 6.2.2. I am able to access it via CLI using the command session sfr with username: admin and password: Admin123.

The issue is that when I go to the webUI, this credentials doesn't work and I am not able to login. It says: Wrong Credentials. Please Login again.

Is there a different credentials to login to the webUI.? How to set it up?

Thank you in advance.

Re: Unable to login to WebUI

bilaal.amin — Mon, 16 Sep 2019 08:35:48 GMT

I did a mistake. The IP I was using to access the Firepower is actually the IP of my core-switch.

My in-built Firepower is managed from the ASDM application only.

Re: Unable to login to WebUI

Marvin Rhoads — Tue, 17 Sep 2019 08:48:22 GMT

Right - a Firepower service module on an ASA does not have its own web UI. It is either managed locally via ASDM or remotely via Firepower Management Center (FMC).