topic Glad that it worked and in Network Security

FMC Error directly after installation "Unable to reach Server"

roesch4alc — Fri, 21 Feb 2020 13:52:47 GMT

Hi,

my customer installed the Firesight Management Center Vmware Image v6.0.1. After that I accessed the system with https://192.168.45.45. The first message I got from the webfrontend was the message you can see in the picture, I attached.

Domain Switching Error / Unable to reach server. Reload this page and try again.

Does somebody know, what that means? Is that a problem or shouldn´t I care about it?

Regards

Sebastian

Hello Team,

Jetsy Mathew — Fri, 29 Jul 2016 08:02:16 GMT

Hello Team,

This clearly indicates the database error in the device. The best way to resolve the issue is to redeploy (reimage ) the device once again so that it will create a new database without any errors. Otherwise you need to open a TAC request to truncate the session table.The best way i would suggest is to redeploy rather than waiting for the escalation and keep on repairing corrupted database

Rate and mark correct if the post helps you

Regards

Jetsy

After I completed the initial

roesch4alc — Fri, 29 Jul 2016 08:04:30 GMT

After I completed the initial setup dialog, now the webinterface won´t load. The webpage is blank and it says "ERR_TOO_MANY_REDIRECTS".

But there is still something happening in the background, different processes consume up to 100%...

Hello Team,

Jetsy Mathew — Fri, 29 Jul 2016 08:11:04 GMT

Hello Team,

The session tables got corrupted and due to which the CPU resources may be going high.

Once during the redeployment , please refer the following guide as well as the 6.0.1 release notes and make sure all necessary resources and requirements met.

http://www.cisco.com/c/en/us/support/docs/security/firesight-management-center-virtual-appliance/118645-configure-firesight-00.html

http://www.cisco.com/c/en/us/td/docs/security/firepower/601/relnotes/firepower-system-release-notes-version-601.html

Rate if the post helps you

Regards

Jetsy

Hi Jetsy,

roesch4alc — Fri, 29 Jul 2016 11:02:00 GMT

Hi Jetsy,

that did the trick. After an new installation, it works fine...Thank you very much 😉

Glad that it worked and

Jetsy Mathew — Fri, 29 Jul 2016 11:14:43 GMT

Glad that it worked and everything good now 🙂

Feel free to write to us...