topic Re: Insert a access-list rule in Network Security https://community.cisco.com/t5/network-security/insert-a-access-list-rule/m-p/666982#M1024654 <HTML><HEAD></HEAD><BODY><P>If you are running 6.3 code, you can add access-list at any position you want. This can be done using "line no." in the access-list command. For eg. I can use following command to add access-list at porion 10 in the existing ACL of 20 lines:</P><P></P><P>access-list 101 line 10 permit ip any any </P><P></P><P>Hope this helps.</P><P></P><P>Regards,</P><P>Vibhor.</P></BODY></HTML> Tue, 27 Feb 2007 22:01:18 GMT vitripat 2007-02-27T22:01:18Z Insert a access-list rule https://community.cisco.com/t5/network-security/insert-a-access-list-rule/m-p/666981#M1024652 <P>Hi, </P><P>If I need to add a new rule in the middle of an exist ACL, do I have to re-write the whole ACL? Can I just add this rule to the right place based on access-list sequence number? </P><P></P><P>Thanks</P> Mon, 11 Mar 2019 09:39:14 GMT https://community.cisco.com/t5/network-security/insert-a-access-list-rule/m-p/666981#M1024652 rico_hao40 2019-03-11T09:39:14Z Re: Insert a access-list rule https://community.cisco.com/t5/network-security/insert-a-access-list-rule/m-p/666982#M1024654 <HTML><HEAD></HEAD><BODY><P>If you are running 6.3 code, you can add access-list at any position you want. This can be done using "line no." in the access-list command. For eg. I can use following command to add access-list at porion 10 in the existing ACL of 20 lines:</P><P></P><P>access-list 101 line 10 permit ip any any </P><P></P><P>Hope this helps.</P><P></P><P>Regards,</P><P>Vibhor.</P></BODY></HTML> Tue, 27 Feb 2007 22:01:18 GMT https://community.cisco.com/t5/network-security/insert-a-access-list-rule/m-p/666982#M1024654 vitripat 2007-02-27T22:01:18Z