topic Hello, i am having the same in Network Security

updated SFR software on ASA5506 to 6.0 but problem with access policy creation

bezmalinovic — Tue, 12 Mar 2019 12:49:56 GMT

Hi All,

I just updated the the SFR software on the ASA5506 to the latest version 6.0, but when I try to create an access control policy it shows the following error:

after you click ok, it just shows the access control policy page without any option to create one.

Any suggestions to solve this problem?

Hi,

Aastha Bhardwaj — Tue, 01 Dec 2015 01:14:08 GMT

Hi,

Are you trying to add the rule on the default access control policy or a new access control policy itself?

Try adding a rule on the Default ACL and see if that works?

Regards,

Aastha Bhardwaj

Rate if that helps!!!

Hello, i am having the same

pzivotic1 — Wed, 16 Dec 2015 09:22:24 GMT

Hello, i am having the same problem. I cannot create new policy nor edit existing one.

When i click on Access Control Policy, it only open default policy which by the way, doesn't apply to

device.In comparasion windows for policy, it is listed two policy "Sourcefire3d / default policy" and"default policy".Can someone shed a little light on this bug?

Hi,

Aastha Bhardwaj — Wed, 16 Dec 2015 15:21:48 GMT

Hi,

So its not actually a bug , until and unless you get some other error , the issue is that even if you delete the policy from GUI , sometimes it is still there in eo_table and cql which causes this issue. We manually have to remove those.

That's why I recommended you to open up a TAC case .

Regards,

Aastha Bhardwaj

Rate if that helps!!!

Hello Aastha,

pzivotic1 — Wed, 16 Dec 2015 21:54:53 GMT

Hello Aastha,

Thank You kindly for Your reply.Thing is i didn't delete policy from GUI nor CLI.After upgrade to Sourcefire 6.0 policy editor doesn't display.When i click on "Access Control Policy" tab,

only for a second policy editor come up and afterwards, it dispaly default policy.Problem is that default policy doesn't apply at all and before upgrade it did.

Regards

Petar