topic SorceFire Portal login credentials different than Cisco.com? in Network Security

SorceFire Portal login credentials different than Cisco.com?

Scott Feda — Tue, 12 Mar 2019 12:49:11 GMT

Hello, Setting up a 5506-X with firepower and when creating a FireAMP connection it takes me to a SourceFire portal to log in. Where do I get those credentials? They aren't the same as my Cisco.com login.

Thanks,

Scott

Scott,

Nikhil Vaidya — Mon, 23 Nov 2015 18:12:16 GMT

Scott,

The FireAMP tab is used for logging into the FireAMP Console and integrating another product, AMP for Endpoints, which requires a FireAMP Subscription. A vague and brief description of the AMP for Endpoints product, is where a connector is installed on end devices for malware protection. It's commonly mistaken that this is required to utilize the Malware license.

The Malware License (also referred to as AMP for Networks) performs file inspection on network traffic. It is utilized by creating a File Policy (under Policies > Files). After creating a File Policy, you then need to add the File Policy to an Access Control rule. Afterwards, any traffic that matches that Access Control rule will go through the File Policy.

Thanks

Thank you Nikhil,

Scott Feda — Mon, 23 Nov 2015 19:33:12 GMT

Thank you Nikhil,

That makes sense. No wonder why my credentials wouldn't work.

Scott

Hi Nikhil

Alvaro Rugama — Fri, 26 Feb 2016 23:21:54 GMT

Hi Nikhil

When setting up an ASA with AMP License, how do we get rid of the following message from the DefenseCenter?

Warning Modules:1,Normal Modules:16,Disabled Modules:10
Module Advanced Malware Protection: Cannot connect to cloud

As you said on the solution of this post, there is no need of credentials when working with AMP for endpoint, however, the warning remain on the console. Is there a way to remove this warning?

Best regards