https://community.cisco.com/t5/network-security/initial-network-config-in-fmc/m-p/3216554#M1040522 Hi,<BR /><BR />FMC is linux based OS, so you don't have the regular "show" commands in there.<BR />You can use commands like "ip address", "ip route" or other linux commands.<BR />But I would not recommend to poke around too much in there in a production environment if not needed.<BR /><BR />br, Micke Tue, 14 Nov 2017 20:15:49 GMT mikael.lahtela 2017-11-14T20:15:49Z https://community.cisco.com/t5/network-security/initial-network-config-in-fmc/m-p/3216197#M1040521 <P>Hello freinds</P> <P>&nbsp;</P> <P>in FMC Cli , what command do i need to enter to see the initial network config , for ex in ngips its "sh network"</P> <P>&nbsp;</P> <P>&nbsp;</P> <P>thanks</P> Fri, 21 Feb 2020 14:44:49 GMT https://community.cisco.com/t5/network-security/initial-network-config-in-fmc/m-p/3216197#M1040521 Ibrahim Jamil 2020-02-21T14:44:49Z https://community.cisco.com/t5/network-security/initial-network-config-in-fmc/m-p/3216554#M1040522 Hi,<BR /><BR />FMC is linux based OS, so you don't have the regular "show" commands in there.<BR />You can use commands like "ip address", "ip route" or other linux commands.<BR />But I would not recommend to poke around too much in there in a production environment if not needed.<BR /><BR />br, Micke Tue, 14 Nov 2017 20:15:49 GMT https://community.cisco.com/t5/network-security/initial-network-config-in-fmc/m-p/3216554#M1040522 mikael.lahtela 2017-11-14T20:15:49Z https://community.cisco.com/t5/network-security/initial-network-config-in-fmc/m-p/3216818#M1040523 <P>what is the equivalent of " sh run" in fmc , i have to see the how the network config looks like from cli</P> Wed, 15 Nov 2017 07:44:33 GMT https://community.cisco.com/t5/network-security/initial-network-config-in-fmc/m-p/3216818#M1040523 Ibrahim Jamil 2017-11-15T07:44:33Z