https://community.cisco.com/t5/network-security/asa-failover-separate/m-p/3337175#M1041339 <P>You can run an ASA with a primary and backup WAN. That applies whether it is a single appliance or an HA pair.</P> <P>&nbsp;</P> <P><A href="https://www.cisco.com/c/en/us/support/docs/security/asa-5500-x-series-next-generation-firewalls/118962-configure-asa-00.html" target="_blank">https://www.cisco.com/c/en/us/support/docs/security/asa-5500-x-series-next-generation-firewalls/118962-configure-asa-00.html</A></P> <P>&nbsp;</P> <P>You cannot easily run two ISPs simultaneously active unless your use case is amenable to policy-based routing.</P> Sat, 24 Feb 2018 15:47:36 GMT Marvin Rhoads 2018-02-24T15:47:36Z https://community.cisco.com/t5/network-security/asa-failover-separate/m-p/3337062#M1041338 <P>I have 2 ASAs with LAN failover. Is it possible to configure failover with 2 internet circuits connected to the wan ports? I mean with 2 separate public IP addresses.If so can you send documentation how to configure it?&nbsp;</P> Fri, 21 Feb 2020 15:25:41 GMT https://community.cisco.com/t5/network-security/asa-failover-separate/m-p/3337062#M1041338 Jay Cambell 2020-02-21T15:25:41Z https://community.cisco.com/t5/network-security/asa-failover-separate/m-p/3337175#M1041339 <P>You can run an ASA with a primary and backup WAN. That applies whether it is a single appliance or an HA pair.</P> <P>&nbsp;</P> <P><A href="https://www.cisco.com/c/en/us/support/docs/security/asa-5500-x-series-next-generation-firewalls/118962-configure-asa-00.html" target="_blank">https://www.cisco.com/c/en/us/support/docs/security/asa-5500-x-series-next-generation-firewalls/118962-configure-asa-00.html</A></P> <P>&nbsp;</P> <P>You cannot easily run two ISPs simultaneously active unless your use case is amenable to policy-based routing.</P> Sat, 24 Feb 2018 15:47:36 GMT https://community.cisco.com/t5/network-security/asa-failover-separate/m-p/3337175#M1041339 Marvin Rhoads 2018-02-24T15:47:36Z