topic Re: FirePOWER IPS Inline Port Channel in Network Security

FirePOWER IPS Inline Port Channel

de1denta — Fri, 21 Feb 2020 14:39:34 GMT

Hi All,

I need to install a Cisco FTD 2100 series appliance to sit inline between our Cisco ASA firewall and LAN switch. The Cisco ASA is connected to the LAN switch using 2 x 1GbE interfaces that are bundled in a port channel.

To ensure that the FTD inspects traffic over both ASA port channel member interfaces, I'm assuming that I need to configure 4 inline interfaces on the FTD (one pair for each port-channel member link) and then place them all in the same inline set? Could someone please confirm?

Re: FirePOWER IPS Inline Port Channel

de1denta — Fri, 10 Nov 2017 14:35:01 GMT

Any ideas anyone?

Re: FirePOWER IPS Inline Port Channel

cristian.carrion — Wed, 14 Mar 2018 15:04:10 GMT

Hi Will,

I have the same doubt as you.
Did you get an answer to your question?

Regards

Re: FirePOWER IPS Inline Port Channel

Abheesh Kumar — Sun, 15 Dec 2019 06:04:22 GMT

https://community.cisco.com/t5/firewalls/firepower-2130-ips-inline-port-channel/td-p/3355366

HTH
Abheesh