topic Re: CiscoWorks Device Import in Network Security https://community.cisco.com/t5/network-security/ciscoworks-device-import/m-p/765132#M1054051 <HTML><HEAD></HEAD><BODY><P>Hi Random Camden,</P><P></P><P>In order for the devices to be placed in a "managed" state in RME (which would be a pre-requisite to using Netconfig), you must have as a minimum, snmp RO access.</P><P></P><P>Regards,</P><P>-Joe</P></BODY></HTML> Tue, 22 May 2007 23:44:02 GMT jreekers 2007-05-22T23:44:02Z CiscoWorks Device Import https://community.cisco.com/t5/network-security/ciscoworks-device-import/m-p/765131#M1054050 <P>RME v3.5</P><P>I am trying to import via CSV.</P><P>The devices can be reached via telnet, but not via SNMP thanks to ACL's on all remote devices.</P><P>I was under the impression that to use NetConfig, I just need Telnet Username/Pass, but the devices will not import as there is no SNMP connectivity. Is there any way of forcing the import??</P> Fri, 21 Feb 2020 09:31:43 GMT https://community.cisco.com/t5/network-security/ciscoworks-device-import/m-p/765131#M1054050 random_camden 2020-02-21T09:31:43Z Re: CiscoWorks Device Import https://community.cisco.com/t5/network-security/ciscoworks-device-import/m-p/765132#M1054051 <HTML><HEAD></HEAD><BODY><P>Hi Random Camden,</P><P></P><P>In order for the devices to be placed in a "managed" state in RME (which would be a pre-requisite to using Netconfig), you must have as a minimum, snmp RO access.</P><P></P><P>Regards,</P><P>-Joe</P></BODY></HTML> Tue, 22 May 2007 23:44:02 GMT https://community.cisco.com/t5/network-security/ciscoworks-device-import/m-p/765132#M1054051 jreekers 2007-05-22T23:44:02Z