topic Re: Can't connect using VPN Client in Network Security

Can't connect using VPN Client

david_casey — Fri, 21 Feb 2020 08:32:39 GMT

I get the following error message after I type in the password and try to connect to one of our remote sites:

The client did not match the firewall policy configured on the central site VPN device. Cisco Systems Integrated Client Firewall should be enabled or installed on your computer.

I uninstall 4.0.3, rebooted, reinstalled 4.0.3 and same thing. I then uninstalled 4.0.3, rebooted, installed 4.7 and same thing.

I was using the McAfee Firewall, but gave ZoneAlarm a try (big mistake there as I'm finding out). I wasn't able to connect at all with VPN using ZoneAlarm so I got rid of that and put on the Sygate Personal Firewall which I actually like a lot better. That's when this problem began.

It *only* happens with one site, the other 15 or so connect up just fine. I checked and other engineers in here are able to connect to this site just fine.

I have spent the last couple of hours searching the 'net and trying different things to no avail.

Can anyone offer up any suggestions?

Dave

Re: Can't connect using VPN Client

jackko — Tue, 22 Nov 2005 21:59:47 GMT

i guess the vpn server is a concentrator, which has configured to accept connection providing the cisco integrated client firewall is enabled.

from the vpn client software, go "options" and select "stateful firewall (always on)".

Re: Can't connect using VPN Client

david_casey — Wed, 23 Nov 2005 15:58:14 GMT

It's working now! Not sure if the reinstall/uninstall of Zone Alarm fixed it or your suggestion. But it's working and that's what counts.

Thanks for the reply!

Dave

Re: Can't connect using VPN Client

david_casey — Mon, 28 Nov 2005 18:13:08 GMT

And of course it's not working now. 🙂

I did a clean install of Windows XP Home on this laptop over the weekend to start fresh. I got into work this morning and tried to VPN to one of our remote sites, same error as before. I checked the log file and this is displayed:

Sev=Warning/2 IKE/0xE300008A

Stateful Firewall (Always On) failed to start.

I am also getting a lot of TrueVector errors in the Event Log. ZoneAlarm has not been anywhere near this laptop since the reinstall so I know it's not a ZA issue.

Dave