Problem with VPN monitor (Site-to-Site VPN using IPSec )

abhi_murali — Fri, 21 Feb 2020 08:32:08 GMT

I am doing a project in Site-to-site VPN using IPSec and monitoring and managing the network using cisco works(VPN/Security Managament solutions V2.0).

My network is working fine...i can ping from both sides and the "show commands" shows that the packets are encrypting and decrypting.but the Cisco VPN monitor dash board is not showing any active tunnels. Instead its showing N/S( the device is not supported).

I am using 2600 routers for VPN setup and simulating ISP with frame-relay setup.

I am really stuck with the problem. anybody please help me.

I am attaching my network diagram, router configurations and snapshots from VPN monitor as a zip file.

regards

Abhi

Re: Problem with VPN monitor (Site-to-Site VPN using IPSec )

a-vazquez — Wed, 23 Nov 2005 18:28:03 GMT

Known problems are unexpected behaviors or defects in VPN Monitor software releases. They are graded according to severity level.

These release notes contain descriptions of:

All severity level 1 or 2 bugs.

Significant severity level 3 bugs.

All customer-found bugs (regardless of severity level).

http://www.cisco.com/en/US/products/sw/cscowork/ps2326/prod_release_note09186a00800ad91c.html#64643

topic Re: Problem with VPN monitor (Site-to-Site VPN using IPSec ) in Network Security

Problem with VPN monitor (Site-to-Site VPN using IPSec )

Re: Problem with VPN monitor (Site-to-Site VPN using IPSec )